I know that Spotify unfortunately doesn't have a setting to force it to output to a specific audio device, but is there a way to really "Hijack" it, meaning to capture its audio AND NOT have it arrive to the default system audio device?Ĭuriously, Airfoil from the same Rogue Amoeba seems to be able to capture audio from an app AND prevent it from spreading to default system audio, strange that with more powerful. It doesn't look like incredible, but I just can't cause item 3 above is not working, audio is not "Hijacked", Spotify keeps sending its audio stream also to system audio, so either I hear superimposed audio tracks, or I need to route it to another virtual device losing macOS native volume control. So that, when I see some video on Youtube I can listen the audio, and when I listen to music on Spotify I can listen enhanced audio, all controlled by the main system volume.
Incoming update filter list for all interfaces is not set Outgoing update filter list for all interfaces is not set Invalid after 0 seconds, hold down 0, flushed after 0 If there is no OSPF Router ID configured, the highest loopback IP address is selected as the OSPF Router ID. Success rate is 100 percent (5/5), round-trip min/avg/max = 2/2/3 ms Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 2/3/4 ms Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds: Let’s ping the loopback IP address from both R1 and R2. We can now see that the OSPF neighborship is established. Let’s start by configuring the physical and loopback interfaces.
We’ll use the network topology below for the sample configuration.
I am going to show you how to configure the loopback interface and loopback address and use it as the Router ID for OSPF.
The ‘ip unnumbered’ configuration command allows you to enable IP processing on a serial interface without assigning it an explicit IP address.
It is also recommended that the unnumbered interface points to a loopback interface since loopbacks do not fail.TACACS+ or RADIUS can use the loopback address as a source address for AAA functions and thereby reducing the administration overhead of having to add every IP address of the router to the AAA server.A loopback interface can also be used to establish a Telnet session from the console port of the device to its auxiliary port when all other interfaces are down.You can also configure the loopback address as the Router ID for routing protocols like OSPF and BGP.A good example is mapping a router’s loopback IP address to its DNS server address.We would reap the following advantages and benefits of having loopback interfaces and loopback addresses in our network: Loopback addresses are not limited to the 127.0.0.0/8 block.